slow-trolling method known as spider rigging has been used for years to catch
boatloads of crappie on almost any body of water in any weather and water
conditions. Boats toting numerous long crappie poles, from bow to stern, are a
common sight on lakes from Texas to North Carolina.
want to troll against the wind and first make a dry run to see what obstacles
that could be in the way.
Depending on your state, loading from two to eight rods on the front of the boat allows you to have a more stable boat for slow trolling. With two persons sitting in the front of the boat, the added weight pushes the boat deeper into the water, stabilizing it, particularly on windy days. This prevents waves from constantly bouncing the poles and making the bait bounce up and down. If the bait is bouncing around a lot, the fish aren't going to bite.
You can even add more weight to the front. At can add sand bags in the bow to stabilize the boat in rough water.
Put your transducer on your trolling motor and the graph up front so you can try to position the boat away from trees and brush piles. Keep a constant vigil on the electronics for speed and direction while watching your rod tips.
A Spider Rig system usually consists of 10-foot
Crappie rods fanned out from side to side. The usual rig is 2 hooks tied on a
three-way swivel and two leader lines. The first leader is about 6 to 8 inches
long, and you could use stiffer monofilament (12-16lb) to make the hook stand
out straight from the main line. Then run a bottom leader (dropper) of 8lb test
about 24 inches for fish holding in a tight school close to cover and extend the
leader to 3 to 4 feet for scattered, suspended fish. This leader would have a
oz egg sinker tied in the middle.
main bait on a spider rig is #2 Crappie hooks with minnows.
poles -- long, graphite or graphite-composite trolling or jigging poles, are
held in rod
anglers rod holders are attached to the boats gunwales. In more recent
years, however, fishermen have begun using high-quality Riser type holders
that won't slip off or twist to the side.
Risers have two to eight rod holders attached to a crossbar, and each crossbar
an upright that has a strong bottom bracket for securing the Riser in the boat.
When properly placed, these holders allow the angler to fish with several poles
spread out at regular intervals across the front, back and/or sides of the boat,
usually a foot or
two apart. Plus the rods are all
close to the fisherman for quick hook sets. Adjust the rod holders so the rod
tips are just a few inches off the water.
Rigged this way, the angler can troll against the wind, under control, with an electric motor and sweep a broad area of water with a variety of levels to find crappie.